Furnace and AC replacement quotes
Replacing both typically costs $8,000 to $15,000 installed, before HST. One request, one free in-home estimate.
Get a Free Quote
What a furnace and AC replacement costs in Ontario
Replacing a gas furnace and central AC together typically costs $8,000 to $15,000 installed, before HST. The equipment tiers you choose set most of the spread. One request on FurnaceQuotes.ca covers both units.
New furnace and central AC in one job
$8,000 to $15,000
Typical installed price in Ontario, before HST. Reviewed October 2026.
- Install time
- Often 1 to 2 days
- Best time to book
- Spring or fallWhen a day without heat or cooling is easy
- Single-stage furnace now
- $4,000 to $6,500
- +Standard central AC later
- $3,800 to $7,000
- =Two visits, entry-level units
- $7,800 to $13,500
Both together, any tier$8,000 to $15,000
The combined range covers better equipment too, so it is not a straight discount. One job saves on labour and repeated work.
Why one job usually beats two
Replaced on different dates, some of the work gets done twice. Doing both at once removes the repeats and lets the installer match every part.
| Work item | Two separate jobs | One combined job |
|---|---|---|
| Indoor coil | Lifted and reset on the new furnace, then replaced with the new AC | Set once, sized to both |
| Removal | Two trips | One trip |
| Permits | Can be needed twice | One application, where required |
| Start-up | Airflow set for the old AC, then reset | Airflow, charge and controls set once |
| Warranty | Two start dates, maybe two companies | One installer for the whole system |
What matching means, in plain words
A central AC has two halves: a condenser outside and a coil inside, on the furnace. Its rated efficiency only holds when those parts and the furnace blower are designed to work together.
- 1
Furnace blower
Pushes air across the coil. It must move the airflow the AC needs, roughly 400 cubic feet per minute per ton.
- 2
Indoor coil
Sits on the furnace. It should match the condenser's capacity and the cabinet's width.
- 3
Line set
Two copper pipes to the condenser. Reuse only if they are the right size, cleaned and pressure tested. Off an old R-22 system, many installers replace them.
- 4
Condenser
Its SEER2 rating holds only for a specific coil and furnace. The AHRI reference number proves the match.
- 5
Thermostat
Has to run the furnace stages and the AC.
When to replace both at once
Do both when the AC is near the end of its life anyway, or when a furnace swap would disturb a coil you will replace soon.
Signs it is time for both
- Your AC is 12 to 15 years old or more
- It uses R-22, common before about 2010. R-22 is no longer made, so recharges are scarce and costly
- You are replacing the furnace this year anyway
- The AC needs a compressor, typically $1,800 to $3,500 on its own
- Upstairs rooms never cool properly
When the AC can stay
Under about 10 years old, running well, coil fits the new cabinet? A furnace-only replacement is usually fine. Ask for the coil fit in writing.
Consider a heat pump or dual fuel instead
If your AC is due, a heat pump can cool in summer and heat for much of the year. With your gas furnace as backup, a dual fuel system typically runs $11,000 to $20,000 installed.
Furnace and central AC: $8,000 to $15,000
- Gas heats the home all winter
- The AC only cools
- Lower upfront cost
Heat pump with gas backup: $11,000 to $20,000
- The heat pump cools and heats in milder weather
- The furnace takes over in deep cold
- Can be eligible for heat pump rebates, with approval before installation
- Higher upfront cost and electricity use
What the quote should list for each unit
Three pieces of equipment means three model numbers. Without them you cannot check the match or compare quotes like for like.
Furnace
Indoors
- Model number, AFUE and BTU input
- Stages and blower type
- Venting route and condensate drain
Indoor coil
On the furnace
- Model number and tonnage
- Width that fits the cabinet
- Coil drain and any transition
Condenser
Outdoors
- Model number, SEER2 and refrigerant
- Line set: new, or reused and flushed
- AHRI reference number for the match
- Venting changes or a chimney liner
- $300 to $1,500
- Condensate pump
- $150 to $350
- Duct changes
- $500 to $3,000+
- Thermostat replacement
- $150 to $600
- Permit fee (municipal)
- $75 to $300
- Gas piping
- $300 to $1,200
Typical add-on prices in Ontario, before HST. Reviewed October 2026. Only some homes need each item.
Also check for removal of both units and parts and labour warranty years for each. Comparing quotes? See how many quotes to get, or run yours through the quote checker.
Want both units quoted with model numbers and an AHRI match?
Get A Free QuoteHow the install days run
Most pairs take one long day or two shorter ones. Heat and cooling are off while the crew works, so plan around the weather.
Out with the old
Refrigerant recovered, both units removed.
Furnace and coil
Set, sealed, vented and drained.
Condenser and line set
Outdoor unit placed, lines connected, disconnect wired.
Leak test and vacuum
Lines pressure tested and pulled into a deep vacuum before the refrigerant is released.
Start-up
Combustion, airflow and charge checked, thermostat set, then a walkthrough.
Rebates and gas safety
Do not plan on a rebate for a furnace and AC pair. Gas work is for a TSSA-registered contractor only.
Rebates: check before you sign
Heat pump rebates do not cover a standalone gas furnace or a cooling-only air conditioner, so do not count on a rebate for a straight furnace or AC replacement.
Ontario's Home Renovation Savings program offers heat pump rebates with eligibility rules by heating fuel, home type and product, and it requires approval before installation. Program rules change often, so check the official pages before you buy and never sign because of a promised rebate amount. New applications for the Canada Greener Homes Loan ended on October 1, 2025.
Gas work in Ontario
In Ontario, only a TSSA-registered contractor, using certified gas technicians, may install or repair gas appliances. Ask for the company's TSSA registration number and the technician's certificate before work starts. We do not certify, license or inspect any company.
Get this quote in your city
- Furnace and AC quotes in Kitchener
- Furnace and AC quotes in Waterloo
- Furnace and AC quotes in Cambridge
- Furnace and AC quotes in Guelph
- Furnace and AC quotes in London
- Furnace and AC quotes in Hamilton
- Furnace and AC quotes in Toronto
- Furnace and AC quotes in Mississauga
- Furnace and AC quotes in Brampton
- Furnace and AC quotes in Oakville
Common questions
Straight answers. If yours is not here, the company can answer it during your free estimate.
How much does it cost to replace a furnace and AC together in Ontario?
The typical installed price for both is $8,000 to $15,000 before HST. Single-stage furnaces with standard ACs sit near the bottom, two-stage or modulating furnaces with variable-speed ACs near the top. Venting, ductwork, the line set and electrical work move the final number.
Does replacing the furnace and AC together save money?
Usually it costs less in labour than two separate jobs, because the coil, removal and start-up are done once. It is not always cheaper in total, since many people pick better equipment when doing both. Ask for a combined price and a furnace-only price from the same visit.
Can I keep my old AC with a new furnace?
Usually, as long as the AC is healthy and its indoor coil suits the new furnace cabinet. The installer lifts the coil, sets the new furnace and reconnects it. An AC older than about 12 to 15 years, or one on R-22, is usually worth replacing at the same time.
What SEER2 rating should I look for?
A standard AC of about 14.3 SEER2 typically costs $3,800 to $7,000 installed, and high-efficiency or variable-speed models $6,500 to $10,500. Southern Ontario's cooling season is short, so pay extra for quieter cooling and humidity control rather than big hydro savings. The rating only holds with a matched coil.
How long does a furnace and AC replacement take?
Most pairs are done in one to two days. A straight swap that reuses the line set can finish in a long day. New venting through a wall, duct changes, a new line set run or extra electrical work usually push it into a second day.
One request for a matched furnace and AC
Answer a few quick questions. A participating local HVAC company confirms the details, checks your home and quotes both units with model numbers.
Takes under a minute. No cost, no commitment.